• OpenBuilds® Documentation
    • OpenBuilds BlackBox X32
      • 1. OpenBuilds BlackBox X32 - Product Tour
      • 2. Configuring BlackBox
        • 2.1 Jumper Settings
          • 2.1.1 Limit Switch Voltage
        • 2.2 Stepper Driver Settings
          • 2.2.1 Current Adjustment
          • 2.2.2 Microstepping (Advanced)
      • 3. Connecting BlackBox
        • 3.1 Connect Power Supply
        • 3.2 Connect Motors
          • 3.2.1 NEMA17s
          • 3.2.2 NEMA23s
          • 3.2.3 NEMA23s (Reversed Y2)
        • 3.3 Connect Tool
          • 3.3.1 Router spindle & IOT Relay
          • 3.3.2 12v 3-Wire Laser Module
          • 3.3.3 24v 4-wire Laser Module
          • 3.3.4 Plasma Cutter
          • 3.3.5 0-10v Analog Signal / VFD
          • 3.3.6 RC Servo
        • 3.4 Connect Limit Switches
          • 3.4.1 OpenBuilds Xtension Limit Switches
          • 3.4.2 Micro Limit Switch Kit
          • 3.4.3 NPN Inductive Sensors
        • 3.5 Connect Probe
          • 3.5.1 OpenBuilds XYZ Probe Plus
          • 3.5.2 OpenBuilds Z Touch Plate
        • 3.6 Connect Door Sensor
        • 3.7 Coolant Output
      • 4. Drivers and Software
        • 4.1 Install Device Drivers
        • 4.2 Fix Windows Power Settings
        • 4.3 Hello World (First Project)
      • 5. Advanced Configurations
        • 5.1 AUX1 Serial Header
      • 6. Frequently Asked Questions
        • 6.1 Troubleshoot Stepper Motors / Identify Coil Wiring
        • 6.2 Electromagnetic Interference (EMI)
        • 6.3 Toubleshoot USB Connection / Firmware Not detected
        • 6.4 Reset into Bootloader Mode
      • 7. Firmware
        • 7.1 Firmware Updates
        • 7.2 Firmware Changelog
        • 7.3 Wifi Setup