OpenBuilds Documentation

This is an old revision of the document!

• OpenBuilds® Documentation
  • OpenBuilds Interface
    • 1. OpenBuilds Interface - Product Tour
    • 2. Connect your Interface
      • 2.1.1 Prepare your BlackBox
        • Prepare BlackBox 4X v2.3 - v2.6
      • 2.1.2 Connect Interface to BlackBox
        • Connect Interface to BlackBox 4X
        • Connect Interface to BlackBox X32
    • 3. Initial Setup
      • 3.1 Firmware Update
        • Method 1: Update via CONTROL
        • Method 2: Update via the Internet/Wifi
        • Method 3: Update via USB Flashdrive
      • 3.2 Prepare USB Flash drive and Setup Wifi
    • 4. Usage Instructions:
      • 4.1 Run a Job
      • 4.2 Probing
      • 4.3 Configuration
      • 4.4 Upload Gcode over Wifi
    • 5. Frequently Asked Questions
      • 5.1 Format Flashdrive as FAT32
      • 5.2 Connect to other Grbl controllers
      • 5.3 Firmware Flashing Error: Not enough space / Flash too Small
      • 5.4 Run/Flash Jumper
      • 5.5 Device Test Mode
      • 5.6 Retrofit older Interfaces for X32
    • 6. Tips and Tricks
      • 6.1 Stacking your Interface onto your BlackBox