-
-
- 2. Connect your Interface
- 2.1.1
Prepare your BlackBox - 2.1.2 Connect Interface to BlackBox
- 3. Initial Setup
- 3.1 Firmware Update
- Method 1: Update via CONTROL
- Method 2: Update via the Internet/Wifi
- Method 3: Update via USB Flashdrive
- 4. Usage Instructions:
- 4.1 Run a Job
- 4.2 Probing
- 4.3 Configuration
- 5. Frequently Asked Questions
- 5.4 Run/Flash Jumper
- 5.5 Device Test Mode
- 6. Tips and Tricks
-
Sidebar
docs:interface:connect-blackbox-x32
This is an old revision of the document!
Table of Contents
2.1.2 Connecting OpenBuilds Interface to OpenBuilds BlackBox X32
Order your OpenBuilds BlackBox X32 Motion Control System
 | IMPORTANT NOTE No 1: Make sure to disconnect the USB cable from the BlackBox: See BlackBox Documentation: Section 5.1 Connecting BlackBox X32 to external Serial devices - this forces BlackBox to switch to the AUX port. When the USB cable is connected to the BlackBox, it forces BlackBox into USB mode (I.e. no communications with the AUX port, and thus no communications with Interface) |
| | IMPORTANT NOTE No 2: Make sure to update your Interface to V1.57 Firmware or later for X32 Support |
2.1.2.1 BlackBox X32 Interface V1.7 or newer
2.1.2.2 BlackBox X32 to an older Interface V1.3/V1.5/V1.6
Connect using the BlackBox X32 to INTERFACE (Retrofit RJ11 to Molex SL-4) Cable
| | IMPORTANT NOTE No 3: See Retrofit older Interfaces for X32 if your have an Interface V1.4, V1.5 or V1.6 |
docs/interface/connect-blackbox-x32.1718627570.txt.gz · Last modified: 2024/08/05 15:15 (external edit)