OpenBuilds Documentation

This is an old revision of the document!

• OpenBuilds® Documentation
  • OpenBuilds BlackBox 4X
    • OpenBuilds BlackBox 4X - Product Tour
    • 1. Assembling BlackBox
      • 1.1 Assembly Instructions
      • 1.2 Assembly Video
    • 2. Configuring BlackBox
      • 2.1 Jumper Settings
        • 2.1.1 Slave Axis Driver
        • 2.1.2 Limit Switch Voltage
        • 2.1.3 Onboard Relay
        • 2.1.4 RGB Logo Backlight (Advanced)
        • 2.1.5 Autoreset (Advanced)
      • 2.2 Stepper Driver Settings
        • 2.2.1 Current Adjustment
        • 2.2.2 Microstepping (Advanced)
    • 3. Connecting BlackBox
      • 3.1 Connect Power Supply
      • 3.2 Connect Motors
        • 3.2.1 NEMA17s
        • 3.2.2 NEMA23s
        • 3.2.3 NEMA23s (Reversed Y2)
      • 3.3 Connect Tool
        • 3.3.1 Dewalt DWP611 / RoutER11 & IOT Relay
        • 3.3.2 12v 3-Wire Laser Module
        • 3.3.3 24v 4-wire Laser Module
        • 3.3.4 Plasma Cutter
        • 3.3.5 0-10v Analog Signal / VFD
        • 3.3.6 RC Servo
      • 3.4 Connect Limit Switches
        • 3.4.1 OpenBuilds Xtension Limit Switches
        • 3.4.2 Micro Limit Switch Kit
        • 3.4.3 NPN Inductive Sensors
      • 3.5 Connect Probe
        • 3.5.1 OpenBuilds XYZ Probe Plus
        • 3.5.2 OpenBuilds Z Touch Plate
      • 3.6 Connect Door Sensor
      • 3.7 Coolant Output
    • 4. Drivers and Software
      • 4.1 Install Device Drivers
      • 4.2 Fix Windows Power Settings
      • 4.3 Hello World (First Project)
    • 5. Advanced Configurations
      • 5.1 AUX1 Serial Header
    • 6. Frequently Asked Questions
      • 6.1 Troubleshoot Stepper Motors / Identify Coil Wiring
      • 6.2 Electromagnetic Interference (EMI)
      • 6.3 Toubleshoot USB Connection / Firmware Not detected
      • 6.4 Using a Laser and IoT Relay - Switchover