OpenBuilds Documentation

Sidebar

docs:xyzprobe:software-gcode

Use the XYZ probe with GCODE commands (Grbl)

Grbl Firmware supports the following probing related GCODE commands:

  • G38.2
  • G38.3
  • G38.4
  • G38.5

Refer to the LinuxCNC Wiki for more details on using these commands: LinuxCNC Documentation: G38.2-G38.5

docs/xyzprobe/software-gcode.txt · Last modified: 2020/05/29 20:35 by admin

Page Tools

All works Copyright © 2017 by OpenBuilds® ,LLC
All rights reserved. This Documentation or any portion thereof including but not limited to (menu structures, images, layout, videos, graphical artwork, logos, names, trademarks, etc.) may not be reproduced or used in any manner whatsoever without the express written permission of OpenBuilds, LLC