Differences

This shows you the differences between two versions of the page.

--- docs:interface:retrofit-x32 [2025/04/07 13:35]
admin
+++ docs:interface:retrofit-x32 [2025/04/07 13:39] (current)
admin
@@ Line 3: / Line 3: @@
 Older OpenBuilds Interface versions (V1.4 to V1.6) may not be 100% compatible with the new OpenBuilds BlackBox X32. If you notice a reboot-loop or you are advised by our support team to perform the retrofit - this page deals with the practical installation of the V-EXT JUMPER.
-The instructions below, once applied, should make these older versions work with the new BlackBox X32
+The instructions below, once applied, may make these older versions work with the new BlackBox X32 (though not guaranteed, it can help some older Interfaces remain usable, otherwise one may need to upgrade to a newer Interface to ensure compatibility)
 === 1. Disassemble the Interface ===
@@ Line 21: / Line 21: @@
 === 3. Install the 3-Way Jumper ===
-Included with current BlackBox X32s, you will locate a spare 3-Way Jumper in the box.
+You'd need a 3-way Jumper (3rd party component, can be ordered from Amazon, Digikey https://www.digikey.com/en/products/detail/adam-tech/MSE-G/9830574 etc)
 {{:docs:interface:retrofit_jumper.png?400}}
-Take the 3-Way Jumper from the BlackBox X32 packaging and install it on the 5V-AUX/5V-USB/5V-MAIN pins of the V-EXT JUMPER.
+Take the 3-Way Jumper and install it on the 5V-AUX/5V-USB/5V-MAIN pins of the V-EXT JUMPER.
 {{:docs:interface:retrofit_3.png?400}}

OpenBuilds Documentation