This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
docs:interface:retrofit-x32 [2022/11/17 20:55] admin |
docs:interface:retrofit-x32 [2024/08/05 15:15] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ==== Retrofitting Interface V1.4-1.6 for use with BlackBox X32 ==== | + | ==== Retrofitting Interface V1.4-V1.6 for use with BlackBox X32 ==== |
Older OpenBuilds Interface versions (V1.4 to V1.6) may not be 100% compatible with the new OpenBuilds BlackBox X32. | Older OpenBuilds Interface versions (V1.4 to V1.6) may not be 100% compatible with the new OpenBuilds BlackBox X32. | ||
Line 18: | Line 18: | ||
{{: | {{: | ||
- | Turn the Interface around carefully (The jumpers we need to access are on the back of the main board) and place it down on the table. | + | Turn the Interface around carefully (The jumpers |
=== 3. Install the 3-Way Jumper === | === 3. Install the 3-Way Jumper === | ||
Line 34: | Line 34: | ||
Make sure the jumper is correctly installed (IMPORTANT: DO NOT LET THE JUMPER CONNECT TO THE GND PIN) | Make sure the jumper is correctly installed (IMPORTANT: DO NOT LET THE JUMPER CONNECT TO THE GND PIN) | ||
- | {{: | + | {{: |
Reassemble the Interface by placing the back panel onto the main body, position the front panel back onto the front, and install the 4x M3x6mm screws (Reverse order from disassembly) | Reassemble the Interface by placing the back panel onto the main body, position the front panel back onto the front, and install the 4x M3x6mm screws (Reverse order from disassembly) | ||
Proceed to connect and test your Interface as normal. | Proceed to connect and test your Interface as normal. |