Differences

This shows you the differences between two versions of the page.

--- docs:blackbox-x32:faq-bootloader [2024/04/29 17:18]
admin
+++ docs:blackbox-x32:faq-bootloader [2024/08/05 15:15] (current)
@@ Line 1: / Line 1: @@
 ==== Place BlackBox X32 into Bootloader Mode ====
+=== Introduction ===
-Make sure to download and install the latest version of OpenBuilds CONTROL.
+If CONTROL is unable to automatically reset your BlackBox X32 into Bootloader mode during a Firmware Flashing operation, it may ask you on-screen to Enter bootloader mode and then to try again:
-[[https://software.openbuilds.com|{{:docs:blackbox-4x:download-button.png?200|}}]]\\
+{{:docs:blackbox-x32:pasted:20240429-172046.png}}
-We will use the two buttons on the front of the BlackBox X32, to put the BlackBox X32into "bootloader" mode - this is a special mode in which the BlackBox X32 waits to receive a firmware update from CONTROL
-  * Hold down the **MODE** button keep holding it down (This will tell the controller to be in FLASH mode when it resets)
+This is the procedure you should apply:
-  * Click the **RESET** button (This resets the controller, so it can boot up into Bootloader mode - it will check MODE is being held down to know whether to go into Bootloader Mode)
+=== Reset into Bootloader Mode ===
+We will use the two buttons on the front of the BlackBox X32, to put it into "bootloader" mode - this is a special mode in which the BlackBox X32 waits to receive a firmware update from CONTROL
+  * Hold down the **MODE** button (keep holding it down) This will tell the controller to be in FLASH mode when it resets
+  * Click the **RESET** button - This resets the controller, so it can boot up into Bootloader mode - it will check MODE is being held down to know whether to go into Bootloader Mode
   * Let go of the **MODE** button
 {{:docs:blackbox-x32:blackbox_-_mode_reset.gif|}}

OpenBuilds Documentation

Differences

Page Tools