Differences

This shows you the differences between two versions of the page.

--- docs:blackbox-4x:connect-rc-servo [2024/10/08 12:14]
admin
+++ docs:blackbox-4x:connect-rc-servo [2024/10/08 12:15] (current)
admin
@@ Line 5: / Line 5: @@
 NB: Advanced functionality, requires you to install a custom version of Grbl-Servo
-  * Grbl Settings: Send $31=255 to adjust the PWM scale to 0-255 (8 bit for Servos)
+  * Grbl Settings: Send $30=255 to adjust the scale to 0-255 (8 bit for Servos)
   * GCODE: Send M3 Sxxx where xxx = 0-255 Absolute Position for the servo to move to
   * You may need to add a G4 Pxxx dwell to allow the servo some time to reach the position before continuing with the GCODE
@@ Line 11: / Line 11: @@
 ==== Firmware ====
-Please flash https://github.com/cprezzi/grbl-servo onto your BlackBox
+Please flash [[https://github.com/cprezzi/grbl-servo|https://github.com/cprezzi/grbl-servo]] onto your BlackBox
 ==== Wiring ====
-> {{:docs:blackbox-4x:jumper-relayopen.png?150}}TIP: Remove the Relay Mode jumper to prevent the relay from clicking on/off rapidly during servo PWM operations
+{{:docs:blackbox-4x:jumper-relayopen.png?150}}
+TIP: Remove the Relay Mode jumper to prevent the relay from clicking on/off rapidly during servo operations
 === BlackBox version 2.6 and newer ===

OpenBuilds Documentation