docs:scribe:drawbotv3 [OpenBuilds Documentation]

docs:scribe:drawbotv3

This is an old revision of the document!

Table of Contents

Configure DrawingBotV3 to use the SCRIBE Pen Lifter
- 1. Machines with a Z-Axis (Not using Servo)
- 2. Machines without a Z-Axis (Using Servo)

Configure DrawingBotV3 to use the SCRIBE Pen Lifter

Inside DrawingBotV3, go to FILE > Preferences

Inside the Preferences video, go to Export Settings > GCode

Configure the Start, End, Pen Down and Pen Up command as shown - depending on whether you want to use the Z-axis or the Servo to lift the Pen

1. Machines with a Z-Axis (Not using Servo)

2. Machines without a Z-Axis (Using Servo)

docs/scribe/drawbotv3.1733486740.txt.gz · Last modified: 2024/12/06 12:05 by admin