-
-
- 1. Installing Scribe Pen Lifter
- 2. Firmware Configuration
- 3. Software Configuration
-
Sidebar
docs:scribe:drawbotv3
This is an old revision of the document!
Table of Contents
Configure DrawingBotV3 to use the SCRIBE Pen Lifter
Inside DrawingBotV3, go to FILE > Preferences
Inside the Preferences video, go to Export Settings > GCode
Configure the Start, End, Pen Down and Pen Up command as shown
1. Machines with a Z-Axis (Not using Servo)
==== 2. Machines without a Z-Axis (Using Servo) ====
docs/scribe/drawbotv3.1733486678.txt.gz · Last modified: 2024/12/06 12:04 by admin