-
-
- 1.1 Product Tour
- 2. Wiring BLOX
- 2.1 Power Supply
- 2.2 Addressable LEDs
- 2.4 RC Servo
- 2.5 Stepper Motors
- 2.6 Limits Inputs
- 2.7 Switched Outputs
- 3. Onboard BLOX Peripherals
- 6. BLOX Firmware Guide
- 6.1 Workspace
- 6.2 Events and Logic
- 6.4 Outputs:
- 6.4.1 Servos
- 6.4.2 Linear Actuators
- 6.4.3 Switched Outputs
- 6.4.4 Logging
- 6.4.5 LEDs
- 6.4.6 Audio: Onboard Beeper
- 6.4.7 Audio: I2S
- 6.4.8 Displays
- 6.6 WIFI
- 6.6.1 WIFI: Setup
- 6.6.2 WIFI: Timesync
- 10. Other Firmwares
- 11. Frequently Asked Questions
-
Sidebar
docs:blox:jumper-limitswitchvoltage
This is an old revision of the document!
Table of Contents
2.1.1 Set your Endstop Voltages
OpenBuilds BLOX can provide power to your limit switches / panel switches / sensors / etc : Please use the jumpers to configure the voltage your endstops need: 5v (the default) would be suitable for most mechanical and optical switches. 24v would be great for inductive sensors. Check your endstops' datasheets to determine which voltage would suit them better.
These jumpers are located underneath the top cover of the BLOX, remove a screw on one of the sides to remove the top cover
Limit1 and Limit2 can each be set to individually as needed:
Set the jumper according to the required voltage for the sensor / limit switches attached:
5V Endstops
12-30V Endstops
docs/blox/jumper-limitswitchvoltage.1722862551.txt.gz · Last modified: 2024/08/05 15:15 (external edit)