-
-
- 1.1 Product Tour
- 2. Wiring BLOX
- 2.1 Power Supply
- 2.2 Addressable LEDs
- 2.4 RC Servo
- 2.5 Stepper Motors
- 2.6 Limits Inputs
- 2.7 Switched Outputs
- 3. Onboard BLOX Peripherals
- 6. BLOX Firmware Guide
- 6.1 Workspace
- 6.2 Events and Logic
- 6.4 Outputs:
- 6.4.1 Servos
- 6.4.2 Linear Actuators
- 6.4.3 Switched Outputs
- 6.4.4 Logging
- 6.4.5 LEDs
- 6.4.6 Audio: Onboard Beeper
- 6.4.7 Audio: I2S
- 6.4.8 Displays
- 6.6 WIFI
- 6.6.1 WIFI: Setup
- 6.6.2 WIFI: Timesync
- 10. Other Firmwares
- 11. Frequently Asked Questions
-
Sidebar
docs:blox:connect-rc-servo
This is an old revision of the document!
Table of Contents
2.4 Connecting BLOX to RC Servo
OpenBuilds BLOX provides support for using an RC servo to raise/lower a pen, in Pen Plotter type applications, or other imaginative uses
2.4.1 Wiring
| BLOX Terminal | Device |
| GND | GND |
| 5V | 5V IN |
| SIG | Servo Signal |
2.4.2 Configuration
2.4.2.1 grblHAL / CONTROL
Make sure to set grblHAL settings (CONTROL > Grbl Settings Tab)
For most standard RC Servos that have moves 180 degrees set
- $33=50 Spindle PWM frequency
- $34=2 Spindle off Value
- $35=2 Spindle min value
- $36=15 Spindle max value
2.4.2.2 LogiBLOX
You can set the Servo Position
docs/blox/connect-rc-servo.1723141874.txt.gz · Last modified: 2024/08/08 18:31 by admin