Differences

This shows you the differences between two versions of the page.

--- docs:software:lightburn [2024/06/24 12:51]
admin
+++ docs:software:lightburn [2024/08/05 15:15] (current)
@@ Line 26: / Line 26: @@
 === 2.5 Click Finish ===
+{{:docs:software:pasted:20240624-125129.png}}
+=== 2.6 Select the correct PORT ===
+{{:docs:software:pasted:20240624-125214.png}}
+=== 2.7 You are now CONNECTED ===
+{{:docs:software:pasted:20240624-125322.png}}
+=== 2.8 Troubleshooting ===
+== 2.8.1 Unable to connect ==
+Firstly, install the Drivers: https://docs.openbuilds.com/doku.php?id=docs:blackbox-x32:install-drivers
+If it still fails to connect, go to Edit Device Settings:
+Make sure your Baud Rate is 115200, and you can try with and without DTR Signal (Enabled seems to work best for the BlackBox X32)
+{{:docs:software:pasted:20240624-125502.png}}
+== 2.8.2 Laser power is not correct, laser is weak, laser is always on ==
+Make sure you have S-value Max set to the correct value (Same as what you Set $30 in Grbl Settings)
+{{:docs:software:pasted:20240624-125634.png}}
+same value as $30 in Grbl Settings
+Also make sure Laser Mode is Enabled
+Save and Reset when Prompted
+{{:docs:software:pasted:20240624-125804.png}}

OpenBuilds Documentation