Differences

This shows you the differences between two versions of the page.

--- docs:scribe:mount-acro [2024/12/03 18:39]
admin
+++ docs:scribe:mount-acro [2024/12/03 19:32] (current)
admin
@@ Line 1: / Line 1: @@
 ===== Install Scribe on an OpenBuilds ACRO =====
-==== 1. Download and install OpenBuilds® CONTROL ====
+Using the two included tee nuts and screws install ACRO Pen lifter with the servo flush to the bottom of the ACRO main plate.
-Using the two included tee nuts and screws install ACRO Pen lifter with the servo flush to the bottom of the ACRO main plate.
+Slide the servo up flush to touch the bottom edge of the main plate
-If you have the laser mounting plate installed, please remove it first
+> TIP: If you have the laser mounting plate installed, please remove it first
-Slide the servo up flush to touch the bottom edge of the main plate
+{{:docs:scribe:pic_2.jpg|}}
-NOTE: The tee nut flange should face into the main plate slot, as shown above
+NOTE: The tee nut flange should face into the main plate slot, as shown below
 No need to over tighten the screws, just snug in place
+{{:docs:scribe:pic_3.jpg|}}

OpenBuilds Documentation