Differences

This shows you the differences between two versions of the page.

--- docs:interface:prepare-blackbox-v2.7 [2020/12/11 19:28]
admin
+++ — (current)
@@ Line 1: / Line 1: @@
-==== Prepare a BlackBox V2.7 to work with OpenBuilds Interface ====
-The following steps are required for OpenBuilds Interface to connect to an OpenBuilds BlackBox v2.7.  Perform all the steps, or you will not be able to connect
-=== a) Remove the top panel of the BlackBox ===
-Remove the 4 screws that hold down the top panel, and then set the panel with the fan attached to the side.
-{{:docs:interface:remove_screws_and_top_lid.png?500|}}
-=== b) Insert the TVS Module onto the ICSP header ===
-Included with your Interface, you will find a "TVS Module"
-{{:docs:interface:surge_protector_board.png?200|}}
-The BlackBox has a 6 pin header labelled ICSP.  It is important that you install this module onto the ICSP header.
-Line up the "ICSP" label on both to be on the same side. The arrow points toward the Power input side of the BlackBox
-[[https://docs.openbuilds.com/lib/exe/detail.php?&media=docs:interface:animation-insert-module.gif|{{:docs:interface:animation-insert-module-600px.gif|}}]]
-=== c) Configure the Jumpers ===
-  * Remove the jumper from USB MODE (if one is fitted)
-  * You can put this jumper onto AUTO RST (if there is not already one installed)
-  * (Some BlackBoxes already come configured as shown, but NB do check the jumpers to be sure)
-{{:docs:interface:set-jumpers-v2.7.png?500|}}
-=== d) Replace the Top Panel ===
-Make sure the Fan is plugged in - then place the top panel with fan back onto the BlackBox and reattach using the 4 screws you removed in step (a) above
-{{:docs:interface:replace_screws_and_top_panel.png?500|}}
-----
- [[{}docs:interface:connect-blackbox|NEXT: Connect your OpenBuilds BlackBox]]

OpenBuilds Documentation

Differences

Page Tools