docs:blox:layout
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
docs:blox:layout [2024/07/16 18:54] admin |
docs:blox:layout [2024/08/15 12:50] (current) admin |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ===== Introduction to the OpenBuilds BLOX Features ===== | + | ====== Introduction to the OpenBuilds BLOX Features |
| {{: | {{: | ||
| Line 7: | Line 7: | ||
| * b) **System Buttons**: | * b) **System Buttons**: | ||
| * Reset: Reboots the Interface | * Reset: Reboots the Interface | ||
| - | * Mode: Can be used to put the Interface | + | * Mode: Can be used to put the BLOX into Bootloader mode for firmware updates via the USB-C Port, and also accessible as a user input button for custom |
| - | * c) SD Card: Used for Data Logging and File Storage for access from your custom firmware | + | * c) **SD Card**: Used for Data Logging and File Storage for access from your custom firmware |
| - | * d) UART: 3.3v Serial Port | + | * d) **UART**: 3.3v Serial Port |
| - | * e) Switched Outputs: MOSFET switched Outputs, 12-30v (Same as input voltage), Max 2A. Can be used with PWM or On/Off control. | + | * e) **Switched Outputs**: MOSFET switched Outputs, 12-30v (Same as input voltage), Max 2A. Can be used with PWM or On/Off control. |
| - | * f) 2x Switch / Limits Inputs: Used for connected limit switches for homing, or can also be used as filtered inputs for panel switches or external devices like relay based sensors | + | * f) 2x **Switch / Limits Inputs**: Used for connected limit switches for homing, or can also be used as filtered inputs for panel switches or external devices like relay based sensors |
| - | * g) 2x Stepper Motors Outputs: Used for connecting Stepper motors | + | * g) 2x **Stepper Motors Outputs**: Used for connecting Stepper motors |
| - | * h) Servo Port: Used for connecting RC Servos | + | * h) **Servo Port**: Used for connecting RC Servos |
| - | * i) Power Input: | + | * i) **Power Input**: 12-30V power Input. DC Barrel connector is Center-positive. Double check polarity before connection |
| - | * j) Beeper: Used for notifications and alerts from your firmware | + | * j) **Beeper**: Used for notifications and alerts from your firmware |
| - | * k) RGB LED Port: Used for connecting an WS2812 based RGB LED Strip, Circle and Matrix. | + | * k) **RGB LED Port**: Used for connecting an WS2812 based RGB LED Strip, Circle and Matrix. |
| - | * l) I2C Bus: Used for connection of Sensors and Modules | + | * l) **I2C Bus**: Used for connection of Sensors and Modules |
| - | * m) SPI Bus: Used for connection of Sensors and Modules | + | * m) **SPI Bus**: Used for connection of Sensors and Modules |
| - | * n) GPIO Pins: Used for connection of Sensors and Modules | + | * n) **GPIO Pins**: Used for connection of Sensors and Modules |
| ---- | ---- | ||
| - | |||
| - | | ||
| - | |||
docs/blox/layout.1721156072.txt.gz · Last modified: 2024/08/05 15:15 (external edit)