Differences

This shows you the differences between two versions of the page.

--- docs:blox:jumper-limitswitchvoltage [2024/08/06 12:12]
admin removed
+++ — (current)
@@ Line 1: / Line 1: @@
-===== 2.1.1 Set your Endstop Voltages =====
-OpenBuilds BLOX can provide power to your limit switches / panel switches / sensors / etc : Please use the jumpers to configure the voltage your endstops need: 5v (the default) would be suitable for most mechanical and optical switches. 24v would be great for inductive sensors. Check your endstops' datasheets to determine which voltage would suit them better.
-> These jumpers are located underneath the top cover of the BLOX, remove a screw on one of the sides to remove the top cover
-Limit 1's and Limit 2's voltages can each be set to individually as needed:
-{{:docs:blox:pasted:20240805-125547.png}}
-Set the jumper according to the required voltage for the sensor / limit switches attached:
-==== 5V Endstops (Default) ====
-{{:docs:blox:pasted:20240805-125635.png}}
-==== 12-30V Endstops (Same as input supply voltage) ====
-{{:docs:blox:pasted:20240805-125356.png}}

OpenBuilds Documentation