Differences

This shows you the differences between two versions of the page.

--- docs:blox:connect-switched-outputs [2024/08/06 13:11]
admin
+++ docs:blox:connect-switched-outputs [2024/08/15 12:53] (current)
admin
@@ Line 1: / Line 1: @@
-===== 2.7 Switched Output =====
+====== 2.7 Switched Output ======
 The Switched Outputs are are used to switch the incoming power supply voltage out to a device.  It can be switched on/off or controlled with PWM (Pulse Width Modulation)
@@ Line 9: / Line 9: @@
   * Suitable for inductive loads
-==== 2.7.1 Wiring ====
+----
-| **Switched Output Example: Motors / LEDs** | **Switched Output Example: Relays** | **Switched Output Example: IoT Relay / Solenoid** |
+===== 2.7.1 Wiring =====
-| {{:docs:blox:pasted:20240805-150114.png}} | {{:docs:blox:pasted:20240805-150135.png}} | {{:docs:blox:pasted:20240805-150210.png}} |
-==== 2.7.2 Configuration ====
+| **BLOX Terminal** | **Device** |
+| GND | Low side Switched leg |
+| V+ | 12-30V (Connected to input power supply positive) |
-=== 2.7.2.1 grblHAL/CONTROL ===
+| **Switched Output Example: Motors / LEDs** | **Switched Output Example: Relays** | **Switched Output Example: IoT Relay / Solenoid** |
+| {{:docs:blox:pasted:20240805-150114.png?300}} | {{:docs:blox:pasted:20240805-150135.png?300}} | {{:docs:blox:pasted:20240805-150210.png?300}} |
-No additional grblHAL settings required
-Use the **M7/M8/M9** commands to control the outputs (Mist/Coolant)
+----

OpenBuilds Documentation