Differences

This shows you the differences between two versions of the page.

--- docs:blox:connect-rc-servo [2024/08/06 12:14]
admin
+++ docs:blox:connect-rc-servo [2024/08/15 12:51] (current)
admin
@@ Line 1: / Line 1: @@
-===== 2.4 Connecting BLOX to RC Servo =====
+====== 2.4 Connecting BLOX to RC Servo ======
-==== 2.4.1 Wiring ====
 OpenBuilds BLOX provides support for using an RC servo to raise/lower a pen, in Pen Plotter type applications, or other imaginative uses
-{{:docs:blox:pasted:20240805-130716.png?600}}
+===== 2.4.1 Wiring =====
+| **BLOX Terminal** | **Device** |
+| GND | GND |
+| 5V | 5V IN |
+| SIG | Servo Signal |
-==== 2.4.2 Configuration ====
+{{:docs:blox:pasted:20240805-130716.png?600}}
-=== 2.4.2.1 grblHAL / CONTROL ===
-Make sure to set grblHAL settings (CONTROL > Grbl Settings Tab)
-For most standard RC Servos that have moves 180 degrees set
-  * **$33=50** Spindle PWM frequency
+----
-  * **$34=2** Spindle off Value
-  * **$35=2** Spindle min value
-  * **$36=15** Spindle max value

OpenBuilds Documentation