Differences

This shows you the differences between two versions of the page.

--- docs:blox:connect-psu [2024/08/05 18:44]
admin
+++ docs:blox:connect-psu [2024/08/15 12:51] (current)
admin
@@ Line 1: / Line 1: @@
-===== 3.1 Connecting BLOX to Power Supply =====
+====== 2.1 Connecting BLOX to Power Supply ======
 | {{:docs:exclamation.png?100|}} | **IMPORTANT WARNING**:  Please note, double check your Polarity - wiring a BLOX with reversed polarity power will destroy it. Also never work on wiring of any sorts while power is on. Double check all wiring before turning on the power supply in case any mistakes were made.  |
@@ Line 7: / Line 7: @@
-| Connecting a power supply via the barrel jack | Wiring to a power supply via the screw terminals |
+| **Connecting a power supply via the barrel jack** | **Wiring to a power supply via the screw terminals** |
 | You can connect a power supply via the Barrel jack: 5.5x2.5mm Connector, Center-Positive. 12-30V. | Alternatively, you can wire a power supply to the two-pin screw terminal provided as well. |
-| {{:docs:blox:pasted:20240805-145303.png}} | {{:docs:blox:pasted:20240805-145230.png}} |
+| {{:docs:blox:pasted:20240805-145303.png?400}} | {{:docs:blox:pasted:20240805-145230.png?400}} |
-| | NB: Set the 115/230v Switch: Before connecting your power supply to mains power, it is critical that you check and set the 115v/230v Switch on the right-side of the PSU: |
+| | NB: Set the 115/230v Switch |
-| | {{:docs:blackbox-x32
-.png?400|}} |
 ----

OpenBuilds Documentation