Differences

This shows you the differences between two versions of the page.

--- docs:blox:connect-limit-switches [2024/08/15 12:52]
admin
+++ docs:blox:connect-limit-switches [2024/08/15 12:52] (current)
admin
@@ Line 23: / Line 23: @@
 ----
-==== 2.6.2 Switch Voltage ====
+===== 2.6.2 Switch Voltage =====
 OpenBuilds BLOX can provide power to your limit switches / panel switches / sensors / etc : Please use the jumpers to configure the voltage your endstops need: 5v (the default) would be suitable for most mechanical and optical switches. 24v would be great for inductive sensors. Check your endstops' datasheets to determine which voltage would suit them better.
@@ Line 35: / Line 35: @@
 Set the jumper according to the required voltage for the sensor / limit switches attached:
-=== 5V Endstops (Default) ===
+==== 5V Endstops (Default) ====
 {{:docs:blox:pasted:20240805-125635.png?200}}
-=== 12-30V Endstops (Same as input supply voltage) ===
+==== 12-30V Endstops (Same as input supply voltage) ====
 {{:docs:blox:pasted:20240805-125356.png?200}}

OpenBuilds Documentation