Differences

This shows you the differences between two versions of the page.

--- docs:blox:connect-limit-switches [2024/08/06 12:15]
admin
+++ docs:blox:connect-limit-switches [2024/08/15 12:52] (current)
admin
@@ Line 1: / Line 1: @@
-===== 2.6 Connecting BLOX to Switches =====
+====== 2.6 Connecting BLOX to Switches ======
 | {{:docs:exclamation.png?60|}} | **IMPORTANT WARNING**: Note: Incorrect wiring can short V+ to GND causing damage to your controller: Double check wiring before powering on.  |
@@ Line 7: / Line 7: @@
 These inputs are also the best choice for all other kinds of switches like toggle, push, lever or relay switches.  The inputs are opto-isolated and can accept switch signals between 0 and 30v. It also has onboard noise filtering.  The filtering and opto-isolation makes these two inputs the ideal choice (if available) for any kind of switched input your project needs.   If they are both in use, you can use GPIO for additional switches.
+----
+===== 2.6.1 Switch Wiring =====
+| **BLOX Terminal** | **Device** |
+| GND | GND |
+| V+ | Power Input (Optional, for powered sensors, filtering or LEDs) |
+| SIG | NO/NC terminal of switch |
-==== 2.6.1 Switch Wiring ====
@@ Line 16: / Line 23: @@
 ----
-==== 2.6.2 Switch Voltage ====
+===== 2.6.2 Switch Voltage =====
 OpenBuilds BLOX can provide power to your limit switches / panel switches / sensors / etc : Please use the jumpers to configure the voltage your endstops need: 5v (the default) would be suitable for most mechanical and optical switches. 24v would be great for inductive sensors. Check your endstops' datasheets to determine which voltage would suit them better.
@@ Line 28: / Line 35: @@
 Set the jumper according to the required voltage for the sensor / limit switches attached:
-=== 5V Endstops (Default) ===
+==== 5V Endstops (Default) ====
 {{:docs:blox:pasted:20240805-125635.png?200}}
-=== 12-30V Endstops (Same as input supply voltage) ===
+==== 12-30V Endstops (Same as input supply voltage) ====
 {{:docs:blox:pasted:20240805-125356.png?200}}
+----

OpenBuilds Documentation

Differences

Page Tools