Differences

This shows you the differences between two versions of the page.

--- docs:blackbox-x32:layout [2023/06/05 12:07]
admin
+++ docs:blackbox-x32:layout [2024/08/05 15:15] (current)
@@ Line 15: / Line 15: @@
     * Probe LED: Lights up when the Probe Input activates
     * Motors Enabled LED:   Indicates when the firmware has the Motor Drivers Enabled. In Grbl Settings set $4=1 (required for BlackBox drivers to function correctly) and $1=255 (to keep motors always enabled)
-  * d) Mode and Reset Buttons:  Reset: Restarts the Firmware; Mode button used to put microcontroller into Bootloader mode
+  * d) Mode and Reset Buttons:  Reset: Restarts the Firmware; Mode button used to put microcontroller into [[docs:blackbox-x32:faq-bootloader|Bootloader mode]]
   * e) Power LED: If the Power LED is Green: Power Input OK
   * f) Current Adjustment:  Adjust stepper driver current, see Section [[docs:blackbox-x32:currentadjustment|2.2.1 Current Adjustment]]

OpenBuilds Documentation