Differences

This shows you the differences between two versions of the page.

--- docs:blackbox-x32:layout [2022/08/24 19:51]
admin
+++ docs:blackbox-x32:layout [2024/08/05 15:15] (current)
@@ Line 9: / Line 9: @@
   * c) Status LEDs
     * Door LED: On when the Door input signal is active
-    * Tool On: Indicates the Tool is Enabled
+    * Tool On: Indicates the Tool is Enabled (Also Relay1)
+    * Tool Rev: Indicated Tool Direction is reversed (Also indicates Relay2)
     * Tool PWM: Shows the proprotional RPM or output power of the PWM/0-10v outputs
     * Coolant LED:  Shows status of the Coolant signal (M8 = on, M9 = off)
     * Probe LED: Lights up when the Probe Input activates
     * Motors Enabled LED:   Indicates when the firmware has the Motor Drivers Enabled. In Grbl Settings set $4=1 (required for BlackBox drivers to function correctly) and $1=255 (to keep motors always enabled)
-  * d) Reset Button:  Restarts the Firmware; Mode button used to put microcontroller into Bootloader mode
+  * d) Mode and Reset Buttons:  Reset: Restarts the Firmware; Mode button used to put microcontroller into [[docs:blackbox-x32:faq-bootloader|Bootloader mode]]
   * e) Power LED: If the Power LED is Green: Power Input OK
   * f) Current Adjustment:  Adjust stepper driver current, see Section [[docs:blackbox-x32:currentadjustment|2.2.1 Current Adjustment]]

OpenBuilds Documentation