docs:blackbox-x32:jumper-relay
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
docs:blackbox-x32:jumper-relay [2024/08/05 15:15] 127.0.0.1 external edit |
— (current) | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ===== 2.1.3 Configure the Relay Output ===== | ||
| - | |||
| - | OpenBuilds BlackBox has an onboard Relay: Using the Jumpers you can select which GCODE Commands activate the Relay. | ||
| - | |||
| - | This allows you to use the relay for various purposes: | ||
| - | |||
| - | === Disable the Relay === | ||
| - | Typical for Lasers, or when you have a Spindle wired to the PWM/0-10v (VFD) Terminals, you are using the [[docs: | ||
| - | |||
| - | With the jumper removed the PWM signal will not be sent to the relay (which would make it chatter) | ||
| - | |||
| - | {{: | ||
| - | |||
| - | === Respond to M3/M5 Tool On/Off Commands === | ||
| - | Typically used when you have the Onboard relay wired to control a Plasma inverter | ||
| - | |||
| - | {{: | ||
| - | |||
| - | === Respond to M8/9 Coolant On/Off Commands === | ||
| - | Typically used to wire a DC-powered air solenoid or water pump to do coolant/ | ||
| - | |||
| - | {{: | ||
| - | |||
| - | === Respond to Spindle Direction Commands / Use with Grbl's " | ||
| - | This is not typically used, it exists for esoteric configurations that cannot be controlled with PWM/0-10v only as one would normally do instead. | ||
| - | This connects the relay to Grbl's spindle-direction pin. M3 should activate the relay, M4 should turn it off (as the relay is single throw, the counter clockwise signal, turns it off) | ||
| - | |||
| - | To use it as an enable, rather refer to Grbl's " | ||
| - | |||
| - | {{: | ||
| - | |||
docs/blackbox-x32/jumper-relay.1722870916.txt.gz ยท Last modified: 2024/08/05 15:15 by 127.0.0.1