docs:blackbox-x32:iot-and-laser
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
docs:blackbox-x32:iot-and-laser [2022/08/19 17:27] 127.0.0.1 external edit |
— (current) | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ===== 6.4 Connecting both an IOT Switching Relay for a Router, and a Laser, to the BlackBox ===== | ||
| - | |||
| - | If you would like to fit both a spindle and a laser to your machine: | ||
| - | * Grbl only has one PWM output | ||
| - | * Easiest method to share this signal between multiple tools, it so add a Single Pole, Double Throw switch to direct the PWM signal between the two devices | ||
| - | * This can also act as a Laser Disarm switch, preventing the laser from firing (safety) | ||
| - | |||
| - | Wiring is as follows: | ||
| - | * PWM from BlackBox, to COMMON pin of switch | ||
| - | * PWM out from one side of the switch, to PWM IN on the Laser Module | ||
| - | * PWM (ON/OFF, as the IoT doesn' | ||
| - | * You can substitute the IoT Relay with Router for other PWM toolheads - the concept remains the same, the switch directs which tool sees the PWM signal from the BlackBox | ||
| - | |||
| - | Software / Firmware: | ||
| - | * Remember to disable/ | ||
| - | * Learn more on [[https:// | ||
| - | |||
| - | ==== 6.4.1 Connection Diagram ==== | ||
| - | |||
| - | {{: | ||
| - | |||
| - | |||
docs/blackbox-x32/iot-and-laser.1660930046.txt.gz ยท Last modified: 2024/08/05 15:15 (external edit)