Differences

This shows you the differences between two versions of the page.

--- docs:blackbox-x32:connect-xtension-limit [2022/08/24 17:58]
admin
+++ docs:blackbox-x32:connect-xtension-limit [2024/08/05 15:15] (current)
@@ Line 2: / Line 2: @@
 ===== 3.4.1 Connecting BlackBox X32 to Limit Switches =====
-Tip: Our Limit switches uses Normally-Open switch wiring, please ensure that you have ''$5=0'' in your Grbl settings
+Tip: Our Limit switches uses Normally-Open switch wiring, please ensure that you have ''$5=7'' in your Grbl settings
 Use a 3-core cable to wire up our Xtension Limit switches.
-| {{:docs:exclamation.png?120|}} | **IMPORTANT WARNING**: Note: Incorrect wiring can short V+ to GND causing damage to your controller: Double check wiring before powering on. If you would like to wire a diffent type of switch, you are welcome to contact our [[ https://openbuildspartstore.com/contact-us-form/|Customer service]]  or [[https://openbuilds.com/forums/|Support Forum]]  for assistance with wiring it, to avoid potential damage |
+| {{:docs:exclamation.png?120|}} | **IMPORTANT WARNING**: Note: Incorrect wiring can short V+ to GND causing damage to your controller: Double check wiring before powering on. You are welcome to contact our [[ https://openbuildspartstore.com/contact-us-form/|Customer service]]  or [[https://openbuilds.com/forums/|Support Forum]]  for assistance with wiring it, to avoid potential damage |
 {{:docs:blackbox-x32:xtension_limits_wiring.png?600|}}

OpenBuilds Documentation