Differences

This shows you the differences between two versions of the page.

--- docs:blackbox-x32:connect-nema23-reversed-y2 [2022/08/22 17:59]
admin
+++ docs:blackbox-x32:connect-nema23-reversed-y2 [2024/08/05 15:15] (current)
@@ Line 6: / Line 6: @@
 > Note if you are not using OpenBuilds Motors, refer to [[docs:blackbox-x32:faq-identify-motor-coils|FAQ: Identify Motor coils]] to identify the coil pairs.  The color codes shown above only apply to OpenBuilds Motors
-On most Belt driven machines, the slave Y Axis motor is mounted facing the opposite direction as the primary Y axis motor. In this configuration, you want to reverse the direction of the Y2 motor's rotation, to ensure that it runs the correct direction. This is easily achieved by simply reversing the wiring order on the Y2 Motor's terminal as shown below
+On most Belt driven machines, the slave Y Axis motor is mounted facing the opposite direction as the primary Y axis motor. In this configuration, you want to //reverse// the direction of the Y2 motor's rotation, to ensure that it runs the correct direction. This is easily achieved by simply __reversing the wiring order on the Y2 Motor's terminal__ as shown below
 {{:docs:blackbox-x32:nema23-reversed-y2.png?600|}}

OpenBuilds Documentation