Differences

This shows you the differences between two versions of the page.

--- docs:blackbox-4x:currentadjustment [2024/09/26 18:53]
admin
+++ docs:blackbox-4x:currentadjustment [2024/09/26 18:53] (current)
admin
@@ Line 13: / Line 13: @@
   * Careful to not overturn the potentiometers and damage them. They sweep only the 270 degree chunk shown in print on the front.
-> **Note:**  Pay attention to the Red {{fa>exclamation|Exclamation}} Exclamation Mark LED below each axis's Current Adjustment Potentiometer: if the driver experiences any fault it will shut down and turn on the LED.
+> **Note:**  Pay attention to the
+ <font inherit/inherit;;#c0392b;;inherit>Red</font>  {{fa>exclamation|Exclamation}} Exclamation Mark LED below each axis's Current Adjustment Potentiometer: if the driver experiences any fault it will shut down and turn on the LED.
 === Fault Indicators ===
@@ Line 31: / Line 32: @@
   * Turn power back on
   * Note: The FAULT will persist until both cleared, and power has been turned off and on, to protect the stepper drivers

OpenBuilds Documentation