If CONTROL is unable to automatically reset your BlackBox X32 into Bootloader mode during a Firmware Flashing operation, it may ask you on-screen to Enter bootloader mode and then to try again:

This is the procedure you should apply:

We will use the two buttons on the front of the BlackBox X32, to put it into “bootloader” mode - this is a special mode in which the BlackBox X32 waits to receive a firmware update from CONTROL

• Hold down the MODE button (keep holding it down) This will tell the controller to be in FLASH mode when it resets
• Click the RESET button - This resets the controller, so it can boot up into Bootloader mode - it will check MODE is being held down to know whether to go into Bootloader Mode
• Let go of the MODE button